Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full - Cone meters Ingestion-build-180956 Clearances

Clearances

NOTE 2 Usually for hardness measurements of coating test forces in the microhardness range in accordance with ISO 6507‑1 are used

systems up to 1 000 V

The tests are conducted in an air stream and the GPACM configurations are challenged with test gases under steady-state conditions

Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full - Cone meters Ingestion-build-180956 Clearances1 Scope This part of ISO 5167 specifies the geometry and method of use (installation and operating conditions) of cone meters when they are inserted in a conduit running full to determine the flow rate of the fluid flowing in the conduit. As the uncertainty of an uncalibrated cone meter might be too high for a particular application, it might be deemed essential to calibrate the flow meter in accordance with Clause 7. This part of ISO 5167 also